NETGEAR S3600 Series User Manual page 311

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
8. From the IPv6 Mode menu, select to enable or disable the IPv6 routing mode for
the VLAN:
• Disable: IPv6 routing is disabled for the VLAN. This is the default setting.
• Enable: IPv6 routing is enabled for the VLAN. The VLAN is capable of IPv6
operation without a global address and uses an EUI-64 based link-local address.
9. From the DHCPv6 Client Mode menu, select to enable or disable DHCPv6 client
mode for the VLAN:
• Disable: DHCPv6 Client Mode is disabled for the VLAN. This is the default setting.
• Enable: DHCPv6 Client Mode is enabled for the VLAN, enabling the VLAN to
receive an IPv6 routing address from a DHCPv6 server on the network.
DHCPv6 Client Mode can be enabled for only one VLAN on the switch.
10. From the Stateless Address AutoConfig Mode menu, select to enable or disable
the stateless address automatic configuration mode for the VLAN.
• Disable: Stateless Address AutoConfig Mode is disabled for the VLAN. This is
the default setting.
• Enable: Stateless Address AutoConfig Mode is enabled for the VLAN. The VLAN
can get an IPv6 routing address through stateless address automatic configuration.
11. From the Admin Mode menu, select to enable or disable routing for the VLAN:
• Disable: Routing is effectively disabled for the VLAN.
• Enable: Routing is enabled for the VLAN. This is the default setting.
12. In the Duplicate Address Detection Transmits field, type the number of duplicate
address detection (DAD) transmits for the VLAN.
The DAD transmits value must be in the range from 0 to 600. The default is 1.
13. In the Life Time Interval field, type the lifetime interval that the VLAN transmits in
router advertisements.
The lifetime interval is the period during which IPv6 neighbors can use the VLAN as
a default router.
The range is from 0 to 9000 seconds. The default is 1800 seconds. The value must
be greater than or equal to the advertisement interval. (See information about the
Adv Interval field below.) If you enter 0, the VLAN cannot be used as the default
routing VLAN.
14. In the Adv NS Interval field, type the retransmission interval that the VLAN transmits
in router advertisements.
The retransmission interval is the period between neighbor solicitation
retransmissions.
The range is from 1000 to 4294967295 milliseconds. The default is 0 milliseconds.
Manage Routing 311 User Manual