Standard Ipv4 Acl Rules; Add A Rule For A Standard Ipv4 Acl - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
For information about the credentials, see Credentials for the device UI on page 34.
4. Click the Login button.
The Dashboard page displays.
5. Select Security > ACL > IP ACL > IP ACL/Rules.
The IP ACL/Rules page displays.
The IP ACL Configuration section displays the total number of IPv4 ACLs, IPv6 ACLs,
and MAC ACLs that are configured on the switch and the maximum number of ACLs
that can be configured.
6. In the IP ACL/Rule Table section, select the check box for the IP ACL.
7. Click the Delete button.
Your settings are saved and the IP ACL is removed.

Standard IPv4 ACL rules

You can define rules for standard IPv4-based ACLs. The access list definition includes
rules that specify whether traffic matching the criteria is forwarded normally or discarded.
NOTE: An implicit "deny all" rule is included at the end of a list with ACL rules.
This means that if an ACL is applied to a packet and if none of the explicit rules
match, then the final implicit "deny all" rule applies and the packet is dropped.

Add a rule for a standard IPv4 ACL

If you already added a standard IPv4 ACL, you can add a rule to the ACL. You can also
add a standard IPv4 ACL and a rule together, as one task. The following procedure
describes both options.
To add a rule for an existing or new standard IPv4 ACL:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
Configure Access Control Lists 465 User Manual