Configure The Storm Control Settings For A Port - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
• Rate Limit: A rate limit is applied to traffic on the port.
• Trap: An SNMP trap is sent.
10. Click the Apply button.
Your settings are saved.
Configure the storm control settings for a
port
You can specify storm control settings for one or more ports. These settings can override
the global storm control settings (see Configure the global storm control settings on
page 423).
To configure storm control settings for a port:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight Cloud Portal or Insight
app, enter the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the device UI on page 34.
4. Click the Login button.
The Dashboard page displays.
5. Select Security > Traffic Control > Storm Control.
The Storm Control page displays.
The following steps refer to the Port Settings section, in which you can enable or
disable the globally configured type of storm control for a specific port. For
Manage Switch Security 425 User Manual