Ibm Pc/At And Compatibles - Yamaha MU100R Owner's Manual

IBM PC/AT and Compatibles

Follow these instructions if you have an IBM PC/AT or compatible com-
puter not equipped with an external MIDI interface. Connect the TO HOST
terminal on the MU100R to one of the computer's serial ports, COM 1 or
COM 2.
IBM PC/AT and Compatible
The instructions below assume you are running Windows95 on your PC. For
using the TO HOST connection with other software and operating systems,
consult your Yamaha dealer. If your computer and music software cannot
recognize the TO HOST connection, you can still use the MU100R by in-
stalling a MIDI interface (internal card or external) to the computer.
Operation
1 Install the included driver software.
For Windows95
Install the included Yamaha CBX Driver for Windows95.
The driver software is on a floppy disk included with the MU100R.
Make sure to thoroughly read the "A:\MIDIDRV\README_E.TXT"
on the disk. This contains essential information on installing and
setting up the driver to your computer.
For Windows3.1
Install the included Yamaha CBX Driver for Windows3.1.
The driver software is on a floppy disk included with the
MU100R. Make sure to thoroughly read the "A:\IBMPC\
CBXT3.WRI" on the disk. This contains essential information on
installing and setting up the driver to your computer.
2 Set the HOST SELECT switch to PC-2.
3 Connect the MU100R to the host computer.
Refer to the illustration above. Use a standard computer cable
(8-pin Mini DIN to 9-pin D-SUB; see page 92).
4 Turn on the the host computer, then the MU100R.
Serial Port
Guided Tour
Setting Up the MU100R in Your Music System
21