Yamaha MU100R Owner's Manual page 95

Individual Outputs
2 Select the desired Part.
From the Multi mode Single Part display, use the [PART -/+]
buttons to select the desired Part for using with the individual
output.
3 Set the Output Select parameter to the desired setting.
Here, we'll set the selected Part to output from the INDIV. OUT-
PUT 1 jack.
The selected Part will now be output only through the INDIV. OUT-
PUT 1 jack. (Output through the main OUTPUT jacks and PHONES
jack is cancelled.)
To select another Part for individual output, repeat steps #2 and
#3 above. You can set additional Parts to be output through the
same jack, or select "ind2" to output a Part or Parts through INDIV.
OUTPUT 2.
For more information on the individual outputs, refer to the Output
Select parameter (page 113) and the Output Select Lock parameter
(page 158).
Routing Drum Sounds to the Individual Outputs
Individual drum sounds can also be routed to the individual outputs.
To do this:
1) Select a Drum Part.
2) Press the [EDIT] button.
3) Select "DRUM," and press the [ENTER] button.
4) Select the desired drum sound (either from the connected MIDI keyboard
5) Call up the Output Select parameter (with the [SELECT >] button) and
For more information on using Drum Parts with the individual outputs, refer to
the Output Select parameter (page 118).
84
To do this:
1) Press the [EDIT] button.
2) Select "OTHERS" with the [SELECT >] button, and press
the [ENTER] button.
3) Select "OutPtSel" (Output Select) with the [SELECT >] but-
ton.
4) Set the parameter to "ind1" with the [VALUE -/+] but-
tons or data dial.
or with the [PART -/+] buttons).
make the desired setting (with the [VALUE -/+] buttons or data dial).
Guided Tour