Error Messages - Yamaha MU100 Owner's Manual

Error Messages

Battery Low!
The battery voltage (for internal memory backup) may be too low. Bring the unit to
your local Yamaha dealer or any other authorized Yamaha service personnel.
Check Sum ERROR!
The checksum of the received System Exclusive message is incorrect. Check the
checksum of the message and try transmitting again.
HOST is Offline!
This message appears when the host computer is not turned on, the connecting cable
is not properly connected, or the sequencing software is not active.
Illegal Data!
A data error resulted during reception of MIDI messages. Try transmitting the data
again, or turn the MU100 off and back on again.
MIDI Buffer Full!
Too much MIDI data is being received by the MU100 at one time. Reduce the amount
of data being sent to the MU100.
No Parameter
The selected parameter for use with the Show Exclusive function does not exist as a
valid parameter.
No RecallPerform!
When performing a Recall in the Performance Edit mode, this message appears if
performance data cannot be recalled because the data has not been saved in the
MU100.
Not Available
This message appears in order to indicate that drum voices cannot be selected when
the Sound Module mode is set to PFM (Performance).
PB Com ERROR!
This message appears when data cannot be properly transmitted between the MU100
and a plug-in board. Unplug the power cord and make sure that the connector of the
plug-in board is properly connected.
Too much MIDI data is being received by the plug-in board at one time. Reduce the
amount of data being sent to the plug-in board.
Rcv CH is OFF!
The selected parameter for use with the Show Exclusive function cannot be con-
verted to a MIDI message value since the Receive Channel for the Part is off. Set the
Receive Channel to an appropriate value.
Appendix
Error Messages
171