Error Messages; Warning Message; Data Messages - Yamaha QX5 Owner's Manual

MESSAGES
ERROR MESSAGES
WARNING MESSAGE
DATA MESSAGES
49
When there has been an error or some unexpected condition. the QX5 will display
the error numbers and messages as follows.
x ERROR-O83 x
MIDI buffer over
Error No. Message Meaning
01 Clock too-fast The buffer for realtime messages (Clock, Start, etc.)
has overflowed.
02 Out of sync Unable to STOP normally, (Too much data, or
tempo too fast).
03 MIDI buffer over The input buffer has overflowed.
04 MIDI data error input data error.
05 Memory full During record, edit or data loading, the memory
has overflowed.
06 Memory Protected You tried to record, edit or load when Memory
Protect was on.
07 TR1 not ready You tried to record or enter Event Edit when track
1 was off.
08 Memory error The battery backed-up data is incorrect.
09 iHegal format Data loaded from MIDI or tape has incorrect format.
(Wrong number of bytes or check sum error).
10 Bad tape level Unable to load from tape.
During recording, if free memory goes below 009, this message will be displayed.
Press any switch to go back to the previous display.
x WARNING x
Memory near full
If Sequence Bulk data is transmitted (in response to a dump request) or received
while not in Load/Save mode, the following messages will be displayed. When
finished, the display will show "Completed" for 1 second. You can press
+ to abort, in which case the display will show "Aborted". The displayed
numbers are explained in Tape Save and Tape Load (p.34-p.35).
* TRANSMIT x * RECEIVE *
TRI 018/134 TRS... TRS 042