Connecting Directly To A Computer; Macintosh And Compatibles - Yamaha MU100 Owner's Manual

Operation
1 Set the HOST SELECT switch to MIDI.
2 Connect the MU100 to the appropriate MIDI device.
Refer to the illustrations above. Use a standard MIDI cable (see
page 92).
3 Turn on the the connected device, then the MU100.
4 If you are using a computer, start up your music software, and
set up the appropriate options on the software for operation with
the MU100.

Connecting Directly to a Computer

The MU100 features a built-in host computer interface, allowing you to di-
rectly connect it to your computer — eliminating the need of installing a
special MIDI interface to your computer. The MU100 can be used with the
following computers: Apple Macintosh and compatibles, IBM PC/AT and
compatibles.
If your computer has a MIDI interface you may want to connect the
MU100 to it, rather than using the host computer interface on the MU100.
(See the section "Connecting to MIDI Devices" on page 33.)
Depending on the computer or interface used, set the HOST SELECT
switch to the appropriate setting: MIDI, PC-1, PC-2 (IBM and compatibles),
or Mac (Macintosh and compaibles). For information on the types of cables
that can be used for connection, see the section "MIDI/Computer Con-
necting Cables" on page 92.

Macintosh and Compatibles

Follow these instructions if you have an Apple Macintosh not equipped with
an external MIDI interface. Connect the TO HOST terminal on the MU100
to the Modem or Printer port on the Macintosh.
Modem or
Printer Port
Macintosh
Guided Tour
Setting Up the MU100 in Your Music System
35