Making Adjustments; Effectuer Des Réglages; Ajustes De Configuración - Delta TECK 590TF Manual

Deck mount faucets (with h2optics technology)

Hide thumbs

Table Of Contents

Table of Contents

ADJUSTING SETTINGS (see Figure 13)

1. Press and hold the Function Button (FB) until the Function Symbol (FS)

appears.

2. Once in the adjustment mode, press and release the Function Button (FB)

until the desired Function Symbol (FS) is displayed, see "Driver Board Quick

Reference Chart" below for function modes and settings.

3. To change Function Code (FC), press and release Toggle Button (TB) until

desired function setting is reached.

4. After changes are complete allow the driver board display to turn off.

5. Disconnect the power from the driver board for 10 seconds and then reconnect

to restart the faucet (see D-1 and E-1, Figure 4A on page 6).

NOTICE

Driver board will leave Adjustment Mode after 10 seconds of inactivity and

reset to previous settings.

FACTORY RESET

1. Press and hold the Function Button (FB) until the function symbol appears see

"Driver Board Quick Reference Chart" below.

2. Once in the adjustment mode, press and release the Function Button (FB) until

"F--" symbol is reached

3. To reset factory default settings, press and hold Toggle Button (TB) until the

'dEF' is displayed (approximiately 5 seconds) then release the Toggle Button

(TB).

4. After approximately 2-second display of "dEF", software reset will be

conducted, and the faucet will restart.

5. The functions "d", "T", "R" and "b" will be reset to the factory default settings as stated in the "Driver Board Quick Reference Chart" below.

Function

Symbol

You can set the distance at which the sensor will detect hands in the wash area.

Sensor Range

Factory Set - 9" (23 cm) from sensor

Auto Timer is a safety mode in the event the sensor continually senses a target. In this

Auto Timer

case, the faucet will stop after the predetermined time period expires.

(faucet shut-off)

Factory Set - 45 seconds

This feature is meant to purge stagnant water from supply lines. The faucet will turn on

after the set amount of hours of inactivity and run the set Rinse Time (r) (see below).

Rinse Cycle

Factory Set - "--" (OFF)

This feature is only active if Rinse Cycle (R) time is chosen.

Rinse Time

The setting determines how long the faucet will turn on during the Rinse Cycle (R).

Factory Set -10 seconds (once enabled)

For Proximity, the buzzer setting does not silence the controller and sensor status

sounds. Buzzer options are ON and - (OFF), the default setting is ON.

Buzzer

Factory Set - On

LED will light up indicating low power.

Sensor LED

enable/disable

Factory Set - On

This feature changes the product into a metering faucet; it will run the full set amount of

time after the user's hands are first detected.

Metering Mode

Auto Timer (T) is disabled when the feature is turned on.

Factory Set - "--" (OFF)

This feature resets specific functions to factory default setting. The specific reset

Factory default

functions are listed as d, T, R, b and W. Each setting value refers to default setting in the

setting

column of Factory Default Setting in this table