Table of Contents
Advertisement
FLUSHING SAFETY
Before flushing a spray system, be sure the
entire system and flushing pails are properly
grounded. Refer to Grounding. Follow the
Pressure Relief Procedure, and remove the
spray tip/nozzle from the spray gun. Always
use the lowest possible fluid pressure, and
maintain firm possible fluid pressure, and
maintain firm metal-to-metal contact between
the spray gun and the pail during flushing to
reduce the risk of fluid injection injury, static
sparking and splashing.
ATTENTION
OPERATIONS
MAINTENANCE PERSONNEL
Safety glasses, gloves and long sleeved
clothing are sensible and highly recommended
precautions when working with industrial
dispensing equipment.
HEATED SYSTEMS
PUR HEATED MATERIALS:
systems are designed to dispense PUR
materials. Those systems are supplied with
ventilation
hoods
requirements, as well as specially designed
system components. DO NOT dispense PUR
material with your heated system UNLESS
your system is designed for that purpose AND
the proper ventilation equipment is installed
and proper ventilation equipment is installed
and operational. Failure to adhere to these
cautions may result in damage to the system
equipment and/or injury to the equipment
users.
HOT MATERIALS BURN!
should be taken when working with or around
heated materials. Severe burns can result if
skin contact occurs.
WEAR PROTECTIVE CLOTHING! Cover all
exposed skin; always include a face shield,
arm shields and gloves.
Some heated
and
proper
ventilation
Extreme care
OVERHEATED MATERIAL IS DANGEROUS!
Do not exceed the maximum temperature
recommended by the material supplier. Turn
off the electricity if the material exceed the
maximum temperature.
OBSERVE
RECOMMENDATIONS!
responsibility to provide adequate ventilation
for this system and to properly dispose of
waste materials as recommended by the
material supplier.
AND
MATERIAL
HANDLING
It
is
your
Advertisement
Table of Contents
