Mitsubishi Electric e Series Service Handbook page 31

[ II Restrictions ]
[2] Cable Connections
1. Schematic Diagram of a Unit and Terminal Block Arrangement
Terminal box
See "Detailed drawing"
Detailed drawing
ø34 Control wiring
over 24 VAC
ø34 Control wiring
over 100 VAC
(1) Remove the front terminal box cover.
(2) Wire the power supply and control wires. The terminal box is covered with a bush.
Cut the bush before connecting wires to the terminal box.
(3) Fasten the power supply wires by the cable strap.
(4) Secure the cable conduit, and then waterproof the area around the pipe with silicon, etc.
(5) Reattach the terminal box cover.
HWE20010
Power supply wiring
(from the side)
279
A
59
59
500
<Service side>
Power supply terminal box
(terminal size: M10)
ø66 Power supply wiring
- 22 -
<Service side>
559
282
Power supply wiring
(from the bottom)
<Unit bottom>
Control wiring
over 100 VAC
<Unit: mm>
A
59
Terminal box
Control wiring
under 24 VAC
GB