Mitsubishi Electric e Series Service Handbook page 155

[ IX Troubleshooting ]
11
2-system side
12
2-system side
Brazed areas
Gas pipe (Cut here.)
Brazed areas
13
2-system side
Pull out.
HWE20010
Fixing plate
M5 screw × 1
< Left side >
Remove the plate holding the injection LEV.
1
Plate: Fixed with M5 screw (3.0±0.3 Nm)
Remove the pipe below and above the LEV by
1
removing the braze from the areas shown in the
figure.
Branch pipe: ø12.7
(EAHV type: 6 locations; EACV type: 2 locations)
Injection pipe: ø6.35 (2 locations)
Cut the gas pipe with a metal saw or a pipe
2
cutter.
* Note that there may be cases where there is not
enough room for a pipe cutter.
Heat the brazed areas, and remove the
3
compressor pipe.
Move the heat exchanger horizontally, and
1
remove it from the unit.
Weight: 52 kg
- 146 -
GB