Mitsubishi Electric e Series Service Handbook page 161

[ IX Troubleshooting ]
Fan Replacement Instructions
Required tools
▪ Screwdrivers (for M5 and M6 screws)
▪ Nippers (for cutting the tie band)
▪ Spanners (for M12 hexagon cap nuts)
▪ Stepladder (approx. 2 m)
▪ Scaffold board (approx. 1150 × 300 × 20 mm)
* Notes on tie band (cable tie with a locking device)
If you accidentally cut the cable tie on tie band during replace-
ment, cut off the tie all the way to the locking device, and
insert a regular cable tie (5 mm max.) through the locking
device.
Fan motor position
< Service side >
Fan motor relay connector position
HWE20010
Cut here.
1B
1A
< Right side >
Relay connector: 1A
Relay connector: 1B
< Right side >
2A
2B
< Opposite side of the service side >
- 152 -
Relay connector: 2A
Relay connector: 2B
< Left side >
GB