Sewing Setting Mode - Janome HORIZON Memory Craft 9480 QC PROFESSIONAL Instruction Book

(9) Format
If the internal memory of the machine or USB flash drive
does not function due to damage to the memory bank,
you need to re-enable it by formatting the memory.
To format the machine's internal memory, press the
machine key and a confirmation message will appear.
Press the OK key to format.
To format a USB flash drive, press the USB key and
the confirmation window will open. Press the OK key to
(9)
format.
CAUTION:
Do not turn off the power or disconnect the USB flash
drive while a warning message is displayed otherwise
it may damage the memory bank.
(10)
NOTE:
• This model supports FAT16 and FAT32 formats only.
If the USB flash drive is not read, check the format of
it (refer to pages 153-154).
• Do not use a USB card reader and USB hub.
(10) Reset All to Defaults
Press the YES key to reset all the parameters to the
original values (factory settings).
After customizing the settings, press the OK key to
enable the new settings.

Sewing Setting Mode

(1) Thread Cut after Auto-Lock
The machine automatically trims the threads after sewing
locking stitches when this option is turned on.
(2) Needle Stop Position
The machine always stops with the needle in the down
position except when sewing buttonholes, specialty
(1)
stitches, monograms, etc. However you can change the
needle stop position to up by pressing the needle up key.
NOTE:
The machine stops with the needle in the down
(2)
position if Foot-up key option is turned on, even if the
needle stop position is set to up position.
(3) Auto Tension
(3)
You can adjust the auto thread tension level by pressing
the "+" or "–" key.
Press the next page key to show the next menu.
143