Machine Settings; Machine Setting Mode; Entering The Setting Mode; Buzzer Sound Setting - Janome DKS100 SE Instruction Book

w
q
e r
e r
q
(+)
(–)

MACHINE SETTINGS

Machine Setting Mode

In the setting mode buzzer sound and needle stop
position can be set to your preference.

Entering the setting mode

Press the setting mode key.
The LCD display shows the buzzer sound setting mode
(01onoF).
Press the upper arrow key to go to the needle stop
position setting mode (02UPdn).
q Setting mode key
w Upper arrow key (

Buzzer sound setting

The buzzer sound can be turned on or off using the
buzzer sound setting. The default setting is ON and "on"
sign is blinking.
Press the "+" of the stitch length adjusting key to turn off
the buzzer sound.
Press the "+" of the stitch width adjusting key to turn on
the buzzer sound.
e Stitch length adjusting key
r Stitch width adjusting key
Press the setting mode key to return to the normal
sewing mode.
NOTE:
Caution buzzer sound cannot be turned off.

Needle stop position setting

You can set the needle stop position to up or down when
the machine stops.
The default setting is DOWN and "dn" sign is blinking.
Press the "+" of the stitch length adjusting key to select
the needle stop position down.
Press the "+" of the stitch width adjusting key to select
the needle stop position up.
e Stitch length adjusting key
r Stitch width adjusting key
Press the setting mode key to return to the normal
sewing mode.

Correcting Deformed Stitch Patterns

The sewing results of stretch stitch patterns may vary
depending on sewing conditions, such as sewing speed,
fabric type, number of layers etc.
If stretch stitch patterns are deformed, correct them by
turning the feed balancing dial with the screwdriver.
If the pattern is compressed, turn the dial in the direction
of "+".
If the pattern is drawn out, turn the dial in the direction of
"–".
q Feed balancing dial
53
)