Yaesu VR-500 Operating Manual page 42

Set Mode
Set Item 23 [Opening Bell]
Function:
Available Values: OFF/1/2/3
Default:
Set Item 24 [Opening Msg]
Function:
Available Values: OFF/User/Default
Default:
Set Item 25 [Msg Edit]
Function:
40
Select the opening "Beep" sequence when the VR-500 is powered on.
OFF: No beep
1: "Pi" (Single Beep)
"Po-Pi" (Two Beeps, Low è High pitch)
2:
3: "Pi-Pi" (Two Beeps, both High pitch)
1
Select the Opening Message when the VR-500 is powered on.
OFF: No Opening Message
User: Set by user via Set Item #25 (see below)
Default: "YAESU VR-500"
Default
Program the Opening Message.
Opening Message Programming:
•
After selecting Set Item 25, rotate the DIAL knob one click clock-
wise while pressing the [FUNC] key to enable programming of
the opening message. You will notice the first entry's place blink.
‚
Rotate the DIAL knob to select the character type (the selections
are [alphabet] and
"ABC"
ƒ
Press the keyboard to enter the desired letter or number.
Example 1: If you select the "ABC" character type in the previous step,
press the [2(MW/MC)] key repeatedly to toggle among the
six characters:
A è B è C è a è b è c è A • • •
Example 2: If you select the "123" character type in the previous step,
press the [2(MW/MC)] key to enter the digit "2".
„
Rotate the DIAL knob clockwise while pressing the [FUNC] key
to move to the next character.
... ‚
Repeat steps
of the desired message. A total of eight characters may be used in
the creation of a message.
†
When you have completed the creation of the message, press the
[ENT(SET)] key momentarily to save the message.
"123" [numeric]).
„
to to program the remaining letters or numbers
VR-500 O M
PERATING ANUAL