To Activate The Band Scope - Yaesu VR-500 Operating Manual

•
Set the radio to the VFO mode by pressing the [CLR(P.SET)] key, if necessary.
‚
Press the [B.S(B.W)] key momentarily.
When the Band Scope is activated, rotate the DIAL knob to move the Channel Marker.
When the Band Scope is activated, you can select the Sweep steps by the rotating the DIAL
knob while pressing the [FUNC] key. The Sweep range may be set by pressing the
[B.S(B.W)] key while pressing the [FUNC] key ("A" mode only).
Two methods of turning off the Band Scope are available:
•
Press the [B.S(B.W)] key to turn the Band Scope off and operate on the channel which
the Channel Marker has marked.
‚
Press the [CLR(P.SET)] key to turn the Band Scope off and operate on the centered
(and displayed) channel (with no effect from the Channel Marker).
VR-500 O
PERATING
T A
O CTIVATE THE
M
ANUAL
Band Scope
B S
AND COPE
29