Table of Contents
Advertisement
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
A new battery can explode if it is installed incorrectly. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. For more information, see the Safety instructions documentation that is shipped with your system.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
4. If applicable, disconnect the power or data cables from the expansion card(s).
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
Figure 59. Removing the system battery
CAUTION:
To prevent damage to the battery connector, you must firmly support the connector while
removing or installing a battery.
2. To install a new system battery:
a. Slide the battery with the positive side facing up under the securing tabs.
b. Press the battery into the connector until it snaps into place.
Safety
instructions.
Before working inside your
riser.
system.
Installing and removing system components
65
Advertisement
Table of Contents
