Table of Contents
Advertisement
The PowerEdge R350 system is a 1U server that supports:
● One Intel Xeon E-2300 series processor or one Intel Pentium processor
● Four DDR4 DIMM slots
● Two redundant AC power supply units
● Up to four 3.5-inch SAS/SATA hot-plug drives
● Up to eight 2.5-inch SAS/SATA hot-plug drives
NOTE:
All instances of SAS, SATA drives are seen as drives in this document, unless specified otherwise.
For more information about supported drives, see the www.dell.com/poweredgemanuals.
Topics:
•
Front view of the system
•
Rear view of the system
•
Inside the system
•
Locating the Express Service Code and Service Tag
•
System information label
•
Rail sizing and rack compatibility matrix
Front view of the system
Figure 1. Front view of 8 x 2.5-inch drive system
Table 1. Features available on the front of the system
Item
Ports, panels, and
slots
1
Left control panel with
iDRAC reset button
2
Drive
3
Right control panel
4
Information tag
8
PowerEdge R350 system overview
PowerEdge R350 system overview
Icon
N/A
N/A
N/A
Description
Contains the system health, and system ID indicator.
NOTE:
To reset the iDRAC without changing any saved
settings press and hold the System Identification button for
at least 16 seconds.
Enables you to install drives that are supported on your system.
Contains the power button, USB port, iDRAC Direct micro port,
and the iDRAC Direct status LED.
The Information tag is a slide-out label panel that contains
system information such as Service Tag, NIC, MAC address, and
so on. If you have opted for the secure default access to iDRAC,
the Information tag will also contain the iDRAC secure default
password.
2
Advertisement
Table of Contents
