Installing The Expansion Card Risers - Dell 34PR7 Installation And Service Manual

2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
For butterfly riser, holding the touch points, lift the expansion card riser from the riser connector on the system board.
Figure 47. Removing the butterfly riser
Next steps
Replace the expansion card

Installing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. If removed, install the expansion cards into the expansion card risers.
Steps
For butterfly riser, holding the touch points, align the expansion card riser with the connector and the riser guide pin on the
system board. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Before working inside your
riser.
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 57