Dell 34PR7 Installation And Service Manual page 62

Figure 53. Removing the BOSS S2 card carrier
3. Using the Phillips #1 screwdriver, remove the screw.
4. Slide the BOSS module out until it is unlocked and remove it from the chassis.
Figure 54. Removing the BOSS S2 module
5. Disconnect the BOSS power cable and the BOSS signal cable from the system board.
6. Using the Phillips #1 screwdriver remove the two screws that secure the BOSS S2 module to the BOSS module bay.
7. Slide out the BOSS S2 module from the BOSS module bay.
62 Installing and removing system components