Dell 34PR7 Installation And Service Manual page 64

3. Connect the BOSS power cable and the BOSS signal cable to the system board.
4. Connect the BOSS module to the chassis by aligning with unlock sign.
5. Slide the BOSS S2 module in to the bay until it is firmly locked.
6. Using the Phillips #1 screwdriver, tighten the screw.
Figure 57. Installing the BOSS S2 module
7. Slide the BOSS S2 card carrier into the BOSS S2 module slot.
8. Close the BOSS S2 card carrier release latch to lock the carrier in place.
Figure 58. Installing the BOSS S2 card carrier
Next steps
1. If removed, install the air
2. Follow the procedure listed in the
64 Installing and removing system components
shroud.
After working inside your system.