Cut Mode
Set the Cut Mode default to determine when the printer should pause for cutting. There are two modes
to choose from:
•
Cut Between Labels
•
Cut at End of Job
In a multiprint job (serialized label, terminal block, breaker box, etc.) cut mode determines if the printer
should pause between each label for cutting the individual labels. If you select Cut at End of Job, all
labels in a serialized sequence, or all labels for each listed block in a terminal or breaker box label
type, will print out as one long string, pausing for cutting only after the last label has been printed.
To set the Cut Mode:
1. Press MENU.
2. Navigate to Cut Mode, then press Enter
3. Navigate to the desired cut mode, then press Enter.
M210/M210-LAB User Manual
.
28