Brady M210 User Manual page 899

Problem
Printer frequently powers OFF.
Printer not responding
Error - "Cut while printing"
Printing from PC
M210/M210-LAB User Manual
Cause
Battery is low.
Battery is dead.
Operating cutter while labels are
still printing.
The M210/M210-LAB printer
CANNOT be connected to a PC,
therefore you cannot print PC
label files on the printer.
Corrective Action
Note: The printer is programmed to
shut off automatically after 10 minutes
of inactivity.
Install 6 fresh AA batteries.
OR
Attach the AC Adapter to the printer
and plug into an electrical outlet. This
will supply immediate power.
If using the lithium ion battery, remove
the battery from the printer and
recharge using the AC adapter.
To use the printer while the lithium ion
battery is being recharged on the AC
adapter, insert 6 AA alkaline batteries
in the battery compartment, or
purchase a second AC adapter to
power the printer while the battery is
charging.
If using the lithium ion battery, remove
the battery from the printer and
recharge on the AC adapter.
To use the printer while the lithium ion
battery is recharging, install 6 new AA
batteries in the battery compartment.
• Cut through the material completely.
• Press Clear
clear error.
• Reprint the label(s).
To obtain a Brady printer that can be
connected to a PC, contact Brady
customer service at
888-250-3082.
key to
70