Xerox Phaser 4500 Reference Manual page 120

Novell NetWare Troubleshooting Step-By-Step
These procedures eliminate cabling, communication, and connection problems associated with
network connected printers. The steps are divided into two groups:
Novell NetWare Hardware Step-by-Step
■
■ Novell NetWare Software Step-by-Step
Note
Novell NetWare Software Step-by-Step assumes that you are connected to a Novell
NetWare network with a Windows OS installed on the client workstation. When both of
these procedures are completed, print a test page from your software application. If the test
page prints, no further system troubleshooting is necessary.
Novell NetWare Hardware Step-By-Step
Note the LED activity on the printer. The green link LED is ON whenever it is connected to an
active network. The amber traffic LED is flickering when data is being received.
1. Verify the following:
■ The cable connections: Use a new cable or connectors if possible
■ Which port your printer is attached to. Connect a functioning network device to your
printer to test the port.
2.
Print the "Configuration Page" from your printer. For information about printing
Configuration pages, go to
3. Review the Connectivity Settings and verify these items:
■ NetWare is enabled
■ Frame Type matches the frame type of the desired file server
Note
To determine your NetWare IPX frame type, type config at the Novell console screen.
On large networks, using multiple IPX frame types, it is critical that the frame type be
set correctly.
PDL is set to your desired PDL (PostScript or PCL) or to Auto
■
■ Primary Server (for NetWare 3.x only) is set to the name of the server which serves
the print queue you have assigned to the Phaser printer
NDS Tree (for NetWare 4.x NDS and later) is set for the correct NDS tree name
■
■ NDS Context (for NetWare 4.x NDS and later) is set for the correct NDS Context
■ Print Server (PServer) Name is set for the name selected for the Phaser printer to act
as a print server
■ Novell Mode is correctly set
4.
If changes are made, reset the printer. Once the printer has been reset, allow approximately
two minutes for the printer to go through a self test, then log onto the network server.
5.
Print out another copy of the "Configuration Page" to verify that the items you modified
were set and kept.
Reference/Features/Front
Phaser™ 4500 Laser Printer
3-39
Novell NetWare
Panel.