Xerox 4215 Reference Manual page 246

FORMS UTILITY FOR THE COAX ENVIRONMENT
Switching form orientation
I-10
•
LINE 130.
As previously mentioned, there are setup commands that must
be sent before instructing the printer to start merging variable
data with a macro. If the LANDSCAPE orientation is required, the
PCL landscape orientation must be issued in addition to the
current page settings. To maintain the page settings as well as
the cursor position (x,y) after a macro has been called, a PCL
PUSH to the stack and POP from the stack must also be issued.
The following is an example of a LANDSCAPE form being called
followed by a PORTRAIT form being called which is followed by
another PORTRAIT form being called. The PCL Escape commands
that are used are explained below.
Landscape Esc&l1O
Top Margin = Zero Esc&l0E
Push Esc&f0S
Macro ID#4 Esc&f4Y
Call Macro Esc&f3X
Pop Esc&f1S
•
•
•
Portrait Esc&l0O
Top Margin = Zero Esc&l0E
Push Esc&f0S
Macro ID#3 Esc&f3Y
Call Macro Esc&f3X
Pop Esc&f1S
Vertical Position Esc*p100Y
Horizontal Position Esc*p100X
•
•
•
Portrait Esc&l0O
Top Margin = Zero Esc&l0E
Push Esc&f0S
Macro ID#1 Esc&f1Y
Call Macro Esc&f3X
Pop Esc&f1S
Vertical Position Esc*p100Y
Horizontal Position Esc*p100X
Note: The cursor position (100,100) is used as an example to
place the variable data 1/3 inch down from the top margin plus
any extra carriage return and line feeds generated (see
"Limitations" section below).
XEROX MRP FAMILY COAX COMMAND REFERENCE
1B266C314F
1B266C3045
1B26663053
1B26663459
1B26663358
1B26663153
1B266C304F
1B266C3045
1B26663053
1B26663359
1B26663358
1B26663153
1B2A7031303059
1B2A7031303058
1B266C304F
1B266C3045
1B26663053
1B26663159
1B26663358
1B26663153
1B2A7031303059
1B2A7031303058