Test Print; Printing; Solaris/Hp-Ux - Xerox WorkCentre 7232 System Administrator Manual

6 UNIX TCP/IP
5) Make sure that the [Remote Cancel Model] is set correctly,
6) Make sure that the [Remote Status Model] is set correctly.
7) Make sure that the [Default Request Priority] is set correctly.
8) Make sure that the [Allow Anyone to Cancel a Request] check box is set
9) Make sure that the [Make This Printer the Default Destination] check box is set
6.
Select [OK].
7.
Read and respond to any displayed system messages.
8.
Continue with Test Print on page 84.

Test Print

To make sure that the machine has been installed on the UNIX TCP/IP network
correctly, a test print should be submitted from each client workstation. Perform the
following steps.
1.
Start the Open Windows application.
2.
Send a test print to the machine.
3.
Repeat the procedure for all workstations that will be sending jobs to the machine.
The UNIX TCP/IP installation is now complete.
If the test print fails, refer to the Problem Solving chapter for assistance.

Printing

Solaris/HP-UX

This section describes printing from workstations running Solaris or HP-UX. Refer to
the manuals supplied with the workstation for full details.
Print (lp)
The lp command is used for printing.
Command format
lp [-d printer name] [-n number of copies] File name
Command options
The following command options are available.
• -d printer name
Specify the printer name registered by the lpadmin command as the -d option. If this
option is omitted, the default printer lp will be used.
84
correctly.
correctly.
Xerox WorkCentre 7232/7242 System Administration Guide