Networked Printer - Xerox WorkCentre 3550 Quick Use Manual

English

Networked Printer

When you connect your printer to a network, you must first configure the
TCP/IP settings for the printer. After you have assigned and verified the TCP/IP
settings, you are ready to install the software on each computer on the
network.
1. Make sure that the printer is connected to your network and powered on.
For details about connecting to the network, refer to
Network on page 13.
2. Insert the supplied CD-ROM into your CD-
ROM drive. The CD-ROM should
automatically run, and an installation
window appears.
• If the installation window does not
appear, click Start and then Run. Type
X:\Setup.exe, replacing "X" with the
letter which represents your CD drive
and click OK.
• If you use Windows Vista, click Start > All programs > Accessories >
Run, and type X:\Setup.exe. If the AutoPlay window appears in
Windows Vista, click Run Setup.exe in Install or run program field,
and click Continue in the User Account Control window.
3. Click Install Software.
4. Click Typical installation for a network
printer and follow the wizard instruction to
select and install the printer.
Note: For Custom install instructions, refer
to the System Administrator
5. After the installation is finished, click
Finish.
If the Test Print operation is successful, continue
on to the next setup procedure in this document.
If the print operation failed, refer to
Troubleshooting on page 35.
18 Xerox WorkCentre 3550
Quick Use Guide
Guide.
Connecting to the