Copying Procedure; Step 1 Selecting Features - Xerox 6204 Copy/Scan Operation Manual

3 Copy

Copying Procedure

This section describes the procedures for making copies. Refer to the sections listed
below for additional detail.

Step 1 Selecting Features ................................................................................................ 46

Step 2 Entering the Copy Quantity................................................................................... 47
Step 3 Scanning the Original............................................................................................ 48
Step 1 Selecting Features
Making a copy begins by displaying the [Copy] screen. Once that is done, set up the
copy job by selecting the necessary features from the [Basic Copy], [Image Quality],
and [More Features] tabs, and then enter the copy quantity.
1
Press the <Copy> button on the control panel to
display the [Copy] screen.
Note:
3
Note:
2
Select the required copy features from those
displayed on the [Basic Copy] tab.
Note:
3
Select the required image quality features from
those displayed on the [Image Quality] tab.
Touching the tab moves it to the top.
Note:
46
You also can display the [Copy] screen by
selecting [Copy] on the [Menu] screen. The
[Menu] screen displays when you press the
<Menu> button on the control panel.
If the [Copy] screen is set up as the default
screen, it will display whenever the machine is
powered on, and after the machine exits Power
Saver mode.
For more information about this tab, refer
to "Setting up the [Basic Copy] selections"
(P.60), which appears later in this chapter.
For more information about this tab, refer
to "Setting up the [Image Quality]
selections" (P.65), which appears later in
this chapter.
<Copy>
Xerox 6204 Wide Format Solution