Xerox 6204 Copy/Scan Operation Manual page 29

Right and Rear Views
17
16
15
(controller not shown)
No. Component
11 Scanner exit port
12 Front return guide
13 Toner supply port
14 Circuit Breaker
15 Power Switch
16 Upper unit release lever
17 Upper unit
18 Manual feed tray (Bypass)
19 Fuser cover
20 Media heater switch
21 Cutter button
22 Cutter cover
23 Roll 1
24 Roll 2 location
WARNING: Never touch a labeled area on hot or sharp parts. You may receive a burn
or incur other injuries.
Xerox 6204 Wide Format Solution
12
11
13
18
14
24
Scanned originals exit here.
Returns scanned originals to the front. An optional Document Catch
Tray may be installed on the rear of the machine. Ask your Xerox
representative for more information about this option.
Toner is added through this port.
Switches the input power to the machine on/off and provides
overcurrent and short circuit protection.
Switches the machine power on/off. (Also called the Standby switch.)
Lift up this lever to open the upper unit.
Open this to clear a paper jam.
Open and load media here when making manual feed copies or prints.
Open this to clear a paper jam.
Switches the media heater on/off.
Powering on the media heater helps prevent the media from wrinkling.
The media heater switch is normally on.
Cuts the lead edge of roll media.
Covers the cutter to cut media. Normally, do not open this cover.
Load roll media here.
A second, optional roll (Roll 2) may be installed below Roll 1.
Machine Components
19
23
22
21
Function
20
2
21