Operating Sequence-Models With Neckjets - Kohler K-702 Installation Manual

15. Operating Sequence - - Models with Neckjets
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is running, as
long as the water temperature does not exceed 104_F (40_C). The heater will disengage at higher temperatures.
IMPORTANT ! Please refer to your Homeowners Guide for detailed instructions on the user keypad and optional
remote control.
- Press Power to turn on the whirlpool. The whirlpool will start at medium flow.
- Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad. An indicator
bar in the center of the keypad shows the water flow volume.
- Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Make sure the slip cover is in place on the pillow, and the pillow is attached to the neckjet body.
- With the whirlpool operating, rotate the outer ring until the neckjet icon is flashing. Press "OK" to activate the
neckjets. The neckjet pulsing action will start at medium speed.
- Increase or decrease the neckjet pulsing action by pressing either the up or down arrow buttons on the keypad.
- To activate or deactivate different modes while the necknets are operating, rotate the outer ring until the desired
mode is flashing and press "OK". (Example: To turn the heater off, rotate dial until heater icon is flashing and
press "OK".
- Press "OK", while the neckjet mode is flashing, to turn off the neckjets.
- Press Power a second time to turn off the whirlpool.
NOTE: A built-in timer automatically stops the whirlpool after approximately 20 minutes of operation.
Kohler Co.
11
A
1018963-2-