Table of Contents
Advertisement
Image Enhancer Adjustments
LIMITER adjustment knob
Adjust the maximum limit to detail added to
enhance the original signal.
CRISP adjustment knob
Adjust the amplitude setting for not enhancing
small-amplitude signals, to be regarded as noise.
DEPEND adjustment knob
Adjust the luminance range for edge enhancement
on the luminance level of the signal.
FREQUENCY adjustment knob
Adjust the center frequency for edge enhancement.
H/V RATIO adjustment knob
Adjust the ratio of horizontal and vertical edge
enhancement settings.
GAMMA adjustment knob
Adjust the gradient of the gamma correction curve.
Edge enhancement
In the high frequency range of the signal required for
image sharpness, there are often small amplitude
components, and simple enhancement would also
increase the noise component (high frequency small
amplitude components).
Use the CRISP and DEPEND knobs to set an
appropriate range, then adjust the sharpness with the
DETAIL GAIN knob.
Adjustment ranges of settings
When the IMAGE ENHANCER button is lit
Adjustment knob
Setting range
H CROP•V LETTER 0 to 99 (240 step) 50 (local setting)∗
DETAIL GAIN
0 to 99 (128 step) 25 (local setting)∗
LIMITER
0 to 99 (64 step)
CRISP
0 to 99 (16 step)
DEPEND
0 to 99 (12 step)
FREQUENCY
0 to 99 (4 step)
H/V RATIO
0 to 99 (8 step)
GAMMA
0 to 99 (64 step)
∗ When the HKPF-525 or HKPF-1125 is installed, the
local settings are used.
10
UNITY (PRESET)
50 (local setting)∗
0 (local setting)∗
53 (local setting)∗
66 (local setting)∗
42 (local setting)∗
50 (local setting)∗
Advertisement
Table of Contents
