Table of Contents
Advertisement
Names and Functions of Parts
Output Selection Section
The output selection section selects the output signal to
which the adjustments in the level adjustment section
apply. When you press one of these buttons, the newly
selected button lights.
Changing the output selection makes all of the
adjustment knobs apply to the selected signal. It is not
possible to make a multiple signal selection.
3 D2 button
4 IMAGE ENHANCER button
1 HD button
Press this to select the high definition video output
signal.
2 D1 button
Press this to select the D1 video output signal.
3 D2 button
Press this to select the D2 video output signal.
4 IMAGE ENHANCER button
Press this to carry out image enhancer adjustments.
When the HKPF-525 HD-NTSC Down-Converter
Board is connected
Only the D2 and IMAGE ENHANCER buttons
operate.
When the HKPF-1125 525-HD Up-Converter
Board is connected
Only the HD and IMAGE ENHANCER buttons
operate.
4
1 HD button
2 D1 button
Memory Section
In the memory section you can save and recall up to 99
sets of settings in the internal memory.
1 MEMORY ADDR. indicator
5 –/+ buttons
1 MEMORY ADDR. (address) indicator
This shows a memory address in the range 01 to 99.
When DIP switch 2 on the internal board is set
to the ON position
The MEMORY ADDR. indicator displays the current
values and settings for each adjustment knob. When
the STORE or LOAD button is pressed, the memory
address is displayed. When loading or storing is
completed, the current values and settings are
displayed again.
2 STORE button
Press this button to store the current adjustment setting
values. Use the –/+ buttons to display the address in
the MEMORY ADDR. indicator, then press the
STORE button once more to carry out the saving
operation.
3 LOAD button
Press this button to recall current adjustment setting
values. Use the –/+ buttons to display the recall
address in the MEMORY ADDR. indicator, then press
the LOAD button once more to carry out the recall
operation.
4 CANCEL button
After pressing the STORE button or LOAD button,
press this button to cancel the operation.
5 –/+ buttons
During a save or recall operation, use these to set the
address shown in the MEMORY ADDR. indicator.
Press the + button to increase the address, and the
– button to decrease the address.
2 STORE button
3 LOAD button
4 CANCEL button
Advertisement
Table of Contents
