Table of Contents
Advertisement
B. OPERATING SEQUENCE
Refer to the chart at right for the proper operating
sequence.
1.
Turn on the whirlpool jets. Adjust each jet for
optimum air/water mixture.
2.
A built-in timer automatically stops the motor after
approximately 20 minutes of operation.
3.
A built-in heater automatically maintains the water
temperature while whirlpool bathing.
15. TROUBLESHOOTING PROCEDURES
A. FLEXJET INSTALLATION
NOTE: The Flexjet O-ring must be correctly positioned,
must be lubricated, and must be in good condition to
permit easy rotation and proper operation.
1.
Install the O-ring onto the first shoulder of the
Flexjet. Lubricate the O-ring with silicone lubricant
to prevent noisy operation of the Flexjet.
2.
Insert the Flexjet into the housing, and lightly push
and rotate the Flexjet until it snaps into position. Do
not force the Flexjet.
NOTE: When installed correctly, the Flexjet should turn
smoothly both clockwise and counterclockwise.
Kohler Co., Kohler, WI
TO
Turn on high
speed whirlpool
massage and
heater.
Turn on low
speed whirlpool
massage and
heater.
To add air and
water to the
Reduce
whirlpool action,
Air and
rotate trim ring
Water
counterclockwise.
To reduce air and
water, turn it
clockwise.
Shut off whirlpool.
Restart whirlpool
after 20 minute
cycle is
complete.
Flexjet Housing
O-Ring (Must Be
Lubricated)
13
METHOD
OBSERVE
Add Air
and
Water
First
Shoulder
Flexjet
BA
113906-2-
(A)
Advertisement
Table of Contents
