Confirm Proper Operation; Operating Sequence-Models Without Neckjets - Kohler K-702 Installation Manual

Heater Indicator
Light
Heater
On/Off
Increases
Flow
Power
Decreases
On/Off Flow
Lighted User Keypad
(for whirlpools without
neckjets)

13. Confirm Proper Operation

Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
- Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.
- Fill the whirlpool to a water level at least 2" (5cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104_F (40_C). The heater will automatically
turn off as the water temperature approaches 104_F (40_C) and will remain off until the water cools.
14. Operating Sequence - - Models without Neckjets
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is running, as
long as the water temperature does not exceed 104_F (40_C). The heater will disengage at higher temperatures.
IMPORTANT ! Please refer to your Homeowners Guide for detailed instructions on the user keypad and optional
remote control.
- Press Power to turn on the whirlpool. The whirlpool will start at medium flow.
- Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad. An indicator
bar in the center of the keypad shows the water flow volume.
- Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Press the heater button to turn the heater off and back on. When illuminated, the indicator light shows that the
water temperature will be maintained up to 104_F (40_C).
- Press Power a second time to turn off the whirlpool.
NOTE: A built-in timer automatically stops the whirlpool after approximately 20 minutes of operation.
A
1018963-2-
Activates Mode
Selected
Flow
Mode
Indicator Bar--
Shows water
flow volume
Power Power
On/Off
Increases
Flow or
Pulse
Indicator Bar--
Shows water
flow volume
Decreases
Flow or
Pulse
Heater
On/Off
Lighted User Keypad
(for whirlpools with neckjets)
10
Turn the jet trim
clockwise to
Neckjet Mode-
decrease the flow
Adjust Pulse
Turn the jet trim
counterclockwise to
increase the flow
Kohler Co.