Table of Contents
Advertisement
B. INSTALL WHIRLPOOL TRIM KIT
Refer to the installation instructions packed with the trim
kit when installing the jet or suction trim.
13. CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use
abrasive cleansers as they may scratch and dull the
bath surface. Use warm water and a liquid detergent to
clean the surface.
14. CONFIRM PROPER OPERATION
A. START-UP WHIRLPOOL
Refer to Important Safety Instructions on Page 2.
Please perform the following so the owner can safely
receive the benefits of whirlpool bathing.
1.
Rotate the jets so they are facing down toward the
basin.
2.
Fill the whirlpool to a water level at least 2" above
the top of the highest jet.
Water temperature in the bath should not exceed
104_F (40_C).
BA
113906-2-
(A)
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in
contact with whirlpool surfaces for long periods of
time. Plaster can be removed by scraping with a wood
edge. Do not use metal scrapers, wire brushes, or other
metal tools. A powder-type detergent may be used on a
damp cloth to provide mild abrasive action to the residual
plaster.
Bath
2" Minimum
Wall
12
Water Line
Jet Trim
Kohler Co., Kohler, WI
Advertisement
Table of Contents
