Stud Pocket Preparation - Kohler Maestro K-842-H Installation Instructions Manual

C. STUD POCKET PREPARATION
Construct a minimum 2x4 recess designed for your
particular installation. Make sure you allow for access to
the pump in the event the unit requires service. When
constructing the framing, allow for the thickness of sub
and finish wall materials.
If an apron wall without a ledge is desired, the finished
apron wall surface must be 1/16" under the bath rim.
The whirlpool can be installed in a corner. Recess or
sunken installations are also possible. Steps 1. through
3. below illustrate suggested stud construction.
Modifications may be needed for other types of
construction.
1. Corner Installation:
construction is illustrated.
2. Recess Installation:
construction is illustrated.
3. Sunken Installation: Refer to Roughing-In notes
on Page 4 for cut-out details. Make sure the
whirlpool is supported by the supporting feet on the
bottom of the whirlpool. Do not hang the
whirlpool by the rim.
Kohler Co., Kohler, WI
The suggested stud
The suggested stud
7
BA
113906-2- (A)