Table of Contents
Advertisement
Introduction and Safety
Safety Rules
The manufacturer cannot anticipate every possible cir-
cumstance that might involve a hazard. The alerts in this
manual, and on tags and decals affixed to the unit, are
not all inclusive. If using a procedure, work method, or
operating technique that the manufacturer does not spe-
cifically recommend, verify that it is safe for others and
does not render the equipment unsafe.
Throughout this publication, and on tags and decals
affixed to the unit, DANGER, WARNING, CAUTION, and
NOTE blocks are used to alert personnel to special
instructions about a particular operation that may be
hazardous if performed incorrectly or carelessly. Observe
them carefully. Alert definitions are as follows:
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTE: Notes contain additional information important to
a procedure and will be found within the regular text of
this manual.
These safety alerts cannot eliminate the hazards that
they indicate. Common sense and strict compliance with
the special instructions while performing the action or
service are essential to preventing accidents.
The operator is responsible for proper and safe use of
the equipment. The manufacturer strongly recommends
that if the operator is also the owner, to read the owner's
manual and thoroughly understand all instructions before
using this equipment.
2
General Hazards
Loss of life. Property damage. Installation must
always comply with applicable codes, standards, laws
and regulations. Failure to do so will result in death
or serious injury.
Equipment damage. Only qualified service personnel may
install, operate, and maintain this equipment. Failure to
follow proper installation requirements could result in death,
serious injury, and equipment or property damage.
Environmental Protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority for a designated collection
point or other information related to proper disposal.
(000001)
Electrical Hazards
Electrocution. Contact with bare wires,
terminals, and connections while generator
(000002)
is running will result in death or serious injury.
Electrocution. Verify electrical system is
properly grounded before applying power.
(000003)
Failure to do so will result in death or serious
injury.
Electrocution. Do not wear jewelry while
working on this equipment. Doing so will
result in death or serious injury.
Electrocution. Water contact with a power
source, if not avoided, will result in death
or serious injury.
DANGER
WARNING
DANGER
DANGER
DANGER
DANGER
Owner's Manual for Power Zone Pro Sync
(000190)
(000182a)
ISO000589
(000144)
(000152)
(000188)
(000104)
Advertisement
Table of Contents
