If Problems Occur - Watchguard V10 User Manual

CHAPTER 3: Getting Started
All models except the V10
Firebox V10
When your appliance has been started and initialized, the
following lights on the front of the device should be lit:
• The Power LED
• The Ready LED
• One of the Private, Public, and DMZ interface speed
indicator lights, if those connections have been made.

If problems occur

If the expected lights are not lit, check the following:
• If the Power LED is not lit, disconnect and reconnect
the power cord. For the V10, disconnect the power cord
from the outlet, not from the appliance.
• If the Ready LED is still blinking after more than five
minutes, use the power switch on the back of the
appliance to turn off the power, and then restart the
appliance and reinitiate the startup process.
• Make sure all data cables and the power cord are fully
seated in their sockets.
28
After you have plugged in the appliance, start the
appliance using the switch on the back. The Ready
LED will blink while the appliance initializes.
When the appliance is ready, the light will stop
blinking and remain lit. This may take two or three
minutes.
Connect the appliance end of the power cable to
the jack on the V10 before you connect the plug end
of the power cable to the AC outlet.
Vcontroller