Some versions of the JRE and JDK for Linux may display
fonts incorrectly. In addition, you may encounter a "font not
found" error.
Cabling the Appliance
The next procedure in the installation process is cabling the
appliance to the Management Station. Refer to the Firebox
Vclass Hardware Guide to make sure you have received all of
the necessary cables.
1
Remove the Firebox Vclass appliance from its
packaging.
2
Place the appliance on any stable flat surface near the
Management Station.
3
Connect the appliance through interface 0 (Private) to
the Management Station using the red crossover
Ethernet cable (or corresponding optical cable
depending upon the Firebox model).
4
Connect the appliance to a nearby power source using
the power cord. If connecting the appliance to a UPS
device, be sure to use the WatchGuard-supplied cable
to connect the two devices through their respective RS-
232 ports.
Start a Firebox Vclass Security Appliance
After you have placed the appliance on a surface near the
Management Station and have made the network connec-
tions, you can power up the Firebox Vclass appliance.
Firebox Vclass User Guide
Cabling the Appliance
N
OTE
27