Watchguard V10 User Manual page 118

CHAPTER 5: Router and Transparent Mode
Set the System IP address
If you are deploying the Vclass appliance in Router Mode,
you must now assign a temporary IP address to interface 0
(Private) for use in the initial configuration. If you are
deploying the device in Transparent Mode, you must set
the System IP. After completing this step, you can log in
with Vcontroller and perform further configuration.
1
From the Devices Found field, select the appliance you
want to configure.
2
Click the Set Interface IP button.
3 To set the System Mode, click Router Mode or
Transparent Mode.
4 For Router Mode, in the Interface 0 IP field, type an
unused IP address from the same subnet as the
Management Station. This IP address will apply only
to Interface 0 (Private).
In the Interface 0 Mask field, type the subnet mask for
this IP address.
5
For Transparent Mode, in the System IP field, type an
unused IP address from the same subnet as the
Management Station. This IP address will apply to all
interfaces on the appliance.
In the System Mask field, type the subnet mask for this
IP address.
86 Vcontroller