Adding Secondary Networks - Watchguard Firebox X1000 User Manual

Chapter 5: Using Policy Manager to Configure Your Network

Adding Secondary Networks

Your configuration may require that you add secondary
networks to any of the Firebox interfaces. For more infor-
mation on secondary networks, see "Adding secondary
networks to your configuration" on page 33.
1
Select Network = > Configuration.
The Network Configuration dialog box appears.
2
Click the Secondary Networks tab.
The Secondary Networks tab appears, as shown in the following
figure.
3
Use the drop-down list in the lower-right portion of the
dialog box to select the interface to which you want to
add a secondary network.
4
Use the field in the lower-left portion of the dialog box
to type an unused IP address from the secondary
network.
When typing IP addresses, type the digits and periods in
sequence. Do not use the TAB or arrow key to jump past the
periods. For more information on entering IP addresses, see
"Entering IP addresses" on page 43.
64 WatchGuard Firebox System