Watchguard Firebox X1000 User Manual page 116

Chapter 6: Managing and Monitoring the Firebox
Routes
Routes
Kernel IP routing table
Destination
Window Use Iface
207.54.9.16
58 eth0
207.54.9.48
19 eth1
198.148.32.0
129 eth1:0
127.0.0.0
9 lo
default
95 eth0
94
The interfaces used in this section are as follows:
eth0 - External (public) interface
eth1 - Trusted (internal) interface
eth2 - Optional (DMZ) interface
ipsec0 - IPSec virtual interface
eth0:0 - Interface alias
fbd0 - Virtual interface used for DVCP VPN tunnel
negotiation
pptp0, 1, 2, etc - PPTP virtual VPN interfaces
lo - loopback interface
wgd0 - External (public) IP address when the
Firebox is set up for PPPoE support. (Because all
traffic passing over this interface is PPPoE- specific,
the IP address that appears is a placeholder value
only and can be ignored.)
The Firebox kernel routing table. These routes are
used to determine which interface the Firebox uses
for each destination address.
Gateway
*
*
*
*
207.54.9.30
Genmask Flags MSS
255.255.255.240 U
255.255.255.240 U
255.255.255.0 U
255.0.0.0 U 3584
* UG
WatchGuard Firebox System
1500 0
1500 0
1500 0
0
1500 0