Watchguard Firebox X1000 User Manual page 297

6
When prompted to enter an IP address, it is
recommended that you use the address that is
currently configured as the default gateway on your
management station. Click OK.
7
Choose the COM port that is open on the management
station. Click OK.
This completes the Flash Disk Management utility.
8
Power-cycle the Firebox and wait until the operation
has been completed.
The Firebox light sequence should look like this:
Armed light: Steady
Sys B light: Steady (Some Fireboxes may flicker but most will be
steady.)
(Do not be concerned with the lights on the Security Triangle
Display indicating traffic between interfaces.)
9
Open a DOS prompt and ping the IP address that you
used for the temporary IP.
Replies should follow, which means the Firebox is now ready for
uploading a configuration.
10 In Policy Manager, select File => Open = >
Configuration File. Select the configuration file you
want to load onto the Firebox and load it into Policy
Manager.
11 In Policy Manager, select File => Save = > To Firebox.
You are then prompted for the IP address of the
Firebox and the Firebox configuration passphrase. Use
the address you used as the temporary IP address
during the flash disk management process and wg as
the passphrase.
12 When the Firebox Flash Disk dialog box appears, click
the button marked Save Configuration File and New
Flash Image.
After the configuration has been uploaded and the Firebox
has been rebooted, the Firebox light sequence should now
look like this:
Armed light: Steady
Sys A light: Steady
User Guide
Method 2: The Flash Disk Management Utility
275