Table of Contents
Advertisement
1 SAFETY INSTRUCTIONS
1.1 Notes on safety
⚫
Wear protective goggles when operating the bonding machine to avoid getting any glue into your eyes.
⚫
Avoid getting the glue onto your skin. If this is not observed, problems such as buurns, inflammation or allergic reactions
could result.
⚫
Avoid drinking, eating and smoking while using the glue.
⚫
If the glue is accidentally ingested, problems such as respiratory difficulties or allergic reactions could result.
⚫
Be careful not to get any of the glue which has been applied to the cloth into your eyes or onto your skin.
If this is not observed, problems such as inflammation or allergic reactions could result.
⚫
Do not immerse the bonding machine in liquid.Otherwise the main unit may leak and cause fire, electric shocks, or
operating problems.
If any liquid leaks from the main unit, immediately turn off the power and disconnect the power plug from the electrical
outlet, and then contact a qualified technician.
⚫
Do not place objects on top of the bonding machine.
⚫
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before
opening the control box cover. Touching areas where high voltages are present will result in serious injury from electric
shocks.
<Environmental requirements>
⚫
Use the machine in an area which is free from sources of strong electrical noise such as electrical line noise or static
electric noise. Sources of strong electrical noise may cause problems with correct operation.
⚫
Any fluctuations in the power supply voltage should be within ±10% of the rated voltage for the machine.
Voltage fluctuations which are greater than this may cause problems with correct operation.
⚫
The power supply capacity should be greater than the requirements for the machine's power consumption.
Insufficient power supply capacity may cause problems with correct operation.
⚫
In the event of an electrical storm, turn off the power and disconnect the power cord from the wall outlet. Lightning may
cause problems with correct operation.
<Installtion>
⚫
Machine installation should only be carried out by a qualified technician.
⚫
Contact your Brother dealer or a qualified electrician for any electrical work that may need to be done.
⚫
Do not connect the power cord until installation is complete.
⚫
Be sure to connect the ground.
If the ground connection is not secure, you run a high risk of serious injury from electric shocks, and problems with correct
operation will also occur.
⚫
All cords should be secured at least 25 mm away from any moving parts. Furthermore, do not excessively bend the cords
or secure them too firmly with staples.
⚫
If using a table which has casters, the casters should be secured in such a way so that they cannot move.
WARNING
CAUTION
BM-2000
1 SAFETY INSTRUCTIONS
1
Advertisement
Table of Contents
