Carrier 40TGV0131UP Service Manual page 95

No. Part name
Drain cap
6
1. Detachment
1) Carry out work of item 1 of 1.
2) Loosen screws (3 positions) fixing th
NOTE :
The drain cap is hung down because a
strap is attached to it (outside).
3) Loosen the cap by turn the drain cap
NOTE :
Be sure to catch drain water using a
bucket, etc. when loosening the drain cap.
The insulating materials are adhered to
the drain cap (outside) and opening part of
the drain pan; be careful that they are not
come off.
If they are come off, stick them as before
using double-faces tape, etc.
4) Turn the drain cap once again to OPEN
2. Attachment
1) Insert the drain cap (inside), turn it to
NOTE :
When attaching the drain cap (inside),
remove dirt attached to the packing.
And tighten in it noting so that the cap is
not slantingly set.
If attaching the drain cap as dust or dirt is
attached or the cap is set slantingly, water
leakage is caused.
2) Turn the drain cap (outside) to →
3) Following to work of item 2 of 1, mount
Procedure
drain cap (outside) and then turn the
drain cap to the arrow mark direction to
remove it.
(inside) for approx. 1 turn to OPEN →
direction and then drain the drain water
accumulated in the drain pan.
→ direction to remove it.
CLOSE → direction until the position
where "Clashed sound" is heard and it
cannot be turned more over
(Position where > mark of the drain pan
matches with > mark of the drain cap
(inside)) and then fix it
direction and then attach it using the
fixing screw as original
the suction grille as before.
CLOSE CLOSE CLOSE
OPEN OPEN OPEN
CLOSE CLOSE CLOSE
OPEN OPEN OPEN
Drain cap Dr Drain cap ain cap
- 95 -
Remarks
Drain cap (outside)
Strap Drain cap fixing screws
Drain cap (inside)
mark mark mar
Drain pan Drain pan Dr ain pan mark mark mar