Carrier 40TGV0131UP Service Manual page 93

No. Part name
Ceiling panel 1. Detachment
4
1) Carry out works of item 1 of 2 and item
2) Remove the flap connector
NOTE :
Unlock the lock of the housing part and
then remove the connector.
3) Loosen the panel fixing 4 screws
4) Slide the panel fixing bracket
5) Push the tentative bracket outward and
2. Attachment
1) Insert the tentative brackets (2 positions)
NOTE :
The ceiling panel has the directional
properties against the indoor unit.
Direct the louver motor wire to the electric
parts box side of the indoor unit.
2) Pass the head of the panel fixing
3) Tighten in the panel fixing screw to fix
4) Following to work of item 2 of 3, attach
5) Connect the louver connector
6) Following to work of item 2 of 2, mount
Procedure
1 of 3.
(CN510, White, 20P) and signal
receiving unit connector (CN214)
connected to the control P.C. board and
then remove the lead wire from the
clamps.
(4 positions) outward.
then remove the ceiling panel.
of the ceiling panel into square holes of
the indoor unit and then hook the panel
tentatively.
screw through hole of the panel fixing
bracket and then slide the panel fixing
bracket inward.
the ceiling panel.
the adjust corner cap as before.
(CN510, White, 20P) as before and then
fix the lead wire with clamp
the electric parts box cover and the
suction grille as before.
Clamp
Electrical
control
box
CN214
Panel fixing screw
Tentative bracket
Push in case Push in case Push in case
of removing of remo ving of remo
Inner side Inner side Inner side
Sliding direction Sliding direction Sliding direction
- 93 -
Remarks
Louver motor wiring
CN510
Signal
receiving
Clamps Clamping claw
Square hole of indoor unit
Electric parts box
Louver motor wiring Louv er motor wir er motor wiring
Louv
Ceiling panel
Square hole of indoor unit
ving
Tentative bracket
Square hole of indoor unit
P anel fixing scre Panel fixing screw anel fixing screw
P anel fixing br anel fixing brac k
Panel fixing bracket
Outer side Outer side Outer side
ing
et