Carrier 40TGV0131UP Service Manual page 73

DN Item
01 Filter sign lighting time
02 Filter stain level
10 Type
11 Indoor unit capacity
12 Line address
13 Indoor unit address
14 Group address
Louver type
19
(Adjustment of air direction)
In automatic cooling/heating, temp.
width of cool → heat, heat →
1E
cool mode selection control point
28 Automatic reset of power failure
Selection of thermostat output
2b
(T10 3 )
2E Selection of HA (T10) terminal
31 Fan (Single operation)
32 Sensor selection
High ceiling selection
5d
(Air volume selection)
Timer setting (Wired remote
60
controller)
42 Self-clean operation time
Selection of louver horizontal
45
discharge position
C2 Current demand X% to outdoor unit
Setting of self-clean operation forced
CC
stop
Function selection item No. (DN) list
Contents
0000: None
0002: 2500H
0004: 10000H
0000: Standard
0001: Heavy stain (Half of standard time)
0000: (1-way air discharge cassette)
0001: (4-way air discharge cassette) to 0037
0000: Undecided
0001: No.1 unit to
0001: No.1 unit to
0000: Individual
0002: Follower unit in group
0000: No louver model
(0002:1-way)
0004: 4-way
0000: 0 deg to
(Cool/heat are reversed with ± (Data value) /
2 against the set temperature)
0000: None
0000: Indoor thermostat ON
0001: ON receiving output of outdoor compressor
0000: Normal (JEMA)
0002: Fire alarm input
0000: Impossible
0000: Body TA sensor
0000: Standard
0001: High ceiling (1)
0003: High ceiling (3)
0000: Operable
0000: None
Set when compressor-ON time is 10 to 60 minutes.
When ON-time is 60 minutes or more,
the double of this operation time setting is set.
0000: Smudging-less setting
0002: Cold draft preventive setting
0050: 50% to
0000: No
• Clean operation is performed in case of stop by HA input.
• HA operation output OFF during clean operation in case of
stop by remote controller
0001: Yes
• Clean operation is not performed in case of stop by HA input.
• HA operation output ON during clean operation in case of
stop by remote controller
- 73 -
0001: 150H
0003: 5000H
0005: Clogging sensor used
0001 to 0034
0030: No.30 unit
0064: No.64 unit
0001: Master unit in group
0001: Swing only
(0003:2-way)
0010: 10 deg
0001: Provided
0001: Card input
(Forgotten to be off)
0001: Possible
0001: Remote controller sensor
0001: Operation prohibited
0000: 0.5 h to 0012: 6h
0100: 100%
At shipment from factory
According to type
0000: Standard
According to model type
According to capacity type
0099: Undecided
0099: Undecided
0099: Undecided
According to model type
0003: 3 deg
(Ts±1.5)
0001: Provided
0000: Thermostat ON
0000: Normal
(HA terminal)
0000: Impossible
0000: Body sensor
0000: Standard
0000: Operable
0002: 1 hour
0000: Smudgingless
setting
0075: 75%
0000: None