IR Remote Control “Room Controller” “Zone Manager” The unit can be used with infrared Remote Control, with the Carrier “Room Controller” or “Zone Manager” remote control. Infrared control instructions are contained in the present manual. Remote controls instructions are contained in the relevant manuals.
40KQV General information Unit operation and maintenance • This unit will only work safely and correctly, if installed and tested by qualified personnel. Read this instruction manual thoroughly before using the • Do not open the remote control to avoid possible damage.
40KQV Unit warning lights and controls E N G L I S H P : Green LED Q : Red LED R : Yellow LED S : Remote control signal receiver Indoor unit LEDs • THE YELLOW LED (R) shows the operation in timer mode.
40KQV Optimum comfort... - Correct cleaning - Before a long shutdown period Optimum comfort and minimum power Correct cleaning consumption • Turn the unit OFF and switch the main supply OFF. Keep room temperature at a comfortable level. Use only a clean, damp cloth and a mild detergent.
40KQV Display of selected functions E N G L I S H 1. Operating mode (from left to right): 6. Unit configuration • Ventilation (fan only) 7. Batteries exhausted indicator • Heating (heat pump models only) 8. Louvre positioning (Flap) •...
40KQV Infrared remote controller • Remove the used batteries and insert new batteries. The remote control uses two alkaline batteries (1.5 V, LR03x2). • Press the reset button “O” with a sharp object to reset the remote control. • Do not use used batteries or batteries of different types, as this may cause the unit to malfunction.
40KQV Use of the remote control E N G L I S H Selection of the operating mode WARNING : (button A) In case of loss or failure of the remote control, address to skilled personnel. With this button the operating mode of the air conditioner can be selected.
40KQV Use of the remote control Selecting the fan speed Louvre positioning (button E) Now this icon is flashing. Use button , to select desired position. Press button for confirmation. The fan speed can be selected by pressing button Now all icons are fixed on display.
40KQV Use of the remote control E N G L I S H DAILY timer (Everyday - button J) Sleep timer procedure “night” (button M) Push the button when the ON or OFF timer is active. The icon will appear on display.
40KQV Troubleshooting After inserting the batteries in the remote control, the display The remote control display does not change when any button does not illuminate: is pressed: • The batteries are exhausted or the polarity is incorrect; replace • The triangle symbol 2 is ON, whilst another signal is being the batteries or check polarity.
Page 12
L010125H96 - 0604 Via R. Sanzio, 9 - 20058 Villasanta (MI) Italy - Tel. 039/3636.1 The manufacturer reserves the right to change any product specifications without notice. June, 2004. Supersedes February, 2004. Printed in Italy...