Epson EB-810E User Manual page 215

Multimedia projector
Hide thumbs Also See for EB-810E:
Table of Contents

Advertisement

Projector Network Settings - Network Menu
Setting
Options
Notified IP Address Various IP
addresses
SNMP
On
Off
Trap IP Address 1
Various IP
addresses
Trap IP Address 2
Community Name
Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
AMX Device
On
Discovery
Off
Description
Enter the IP address to receive the
projector's operating status when the
PJLink notification function is enabled.
Enter the addresses using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255 (where
x is a number from 0 to 255).
Set to On to monitor the projector
using SNMP. To monitor the projector,
you need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
Enter up to two IP addresses to receive
SNMP notifications, using 0 to 255 for
each address field.
Do not use these addresses: 224.0.0.0
through 255.255.255.255 (where x is a
number from 0 to 255).
Enter the SNMP community name.
You must set the Community Name
when using the SNMP function for the
first time.
Set to On when you want to allow the
projector to be detected by AMX Device
Discovery.
Setting
Options
Crestron
On
Connected
Off
Password
Up to 20
alphanumeric
characters
Crestron XiO
On
Cloud
Off
Control4 SDDP
On
Off
Art-Net
On
Off
Description
Set to On only when monitoring or
controlling the projector over the network
using Crestron Connected.
Enabling Crestron Connected disables
the Epson Message Broadcasting feature
in the Epson Projector Management
software.
Enter a password to enable Crestron
Connected. No password is set by
default.
Set to On to monitor or control your
projector and other devices over the
network using the Crestron XiO Cloud
service.
Set to On to allow device information
to be acquired using Control4 Simple
Device Discovery Protocol (SDDP).
Set to On when you want to control the
projector using Art-Net.
• Net: enter a number for the projector's
Net using 0 to 127 (default is 0).
• Sub-Net: enter a number for the
projector's Sub-Net using 0 to 15
(default is 0).
• Universe: enter a number for the
projector's Universe using 0 to 15
(default is 0).
• Start Channel: enter the start channel
that handles Art-Net using 1 to 495
(default is 1).
215

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eb-815e

Table of Contents